Rfid Activation - ROLEC OCPP0410 Installation & Operation Manual

EVCharge.Online Driver application. Go to your Profile, then select the RFID option, Add
New RFID+.
Follow the on-screen instructions to add the card/fob.
Once a card/fob is registered on the system at one charge point, the same cards/fobs will
function with all charge points within the same management group, unless restricted by
the Host.

RFID Activation

1. Connect the EV vehicle to the charger with its charging cable.
2. To activate the charger, touch the RFID sensor with the card/fob. The charger will
communicate with the Back Office and, if authorised for use, the charger will
become 'live' and able to supply power to the connected socket.
A low volume 'beep' will be sounded, and the LED indicator will show a quick
red flash when the RFID card/fob is recognised, and you may hear the
electronic switches move into position inside the charger.
If the beep/sound does not happen and/or the charge does not start, make
sure the card/fob has been correctly paired with the system and/or you have
been allowed by the Host to use the specific charge point.
The LED will flash green while the RFID card/fob is being authorised and will turn
solid green when charging starts.
3. Power will continue to be supplied to the vehicle until one of the following events
occur:
The vehicle is fully charged.
The cable is unplugged from the vehicle.
The time or kW limit allocated for charging is reached (set via Back Office
configuration).
The RFID card/fob is held against the RFID sensor again.
The charge session is stopped via the online application.
A charging fault occurs.
EV Driver Application
For operation of the system using the online application, please refer to the EV Driver App
User Guide at the end of this manual.
EVQROCM-01-V01-R0 Installation and Operation Manual
September 2020
Operation
Quantum:EV OpenCharge
Page 19 of 21