Backup To Sd Memory Card; Restore From Sd Memory Card - OHAUS 7000 Series Service Manual

CHAPTER 2 TROUBLESHOOTING
2.10

Backup to SD Memory Card

1 Remove power from the terminal and insert the SD memory card if not already installed. Refer to
Figure 2-7 for location of SD memory card.
2 Apply power, enter setup and access the backup procedure at Maintenance > Backup to SD.
3 At the Dataset Name parameter, press ENTER to program the saved file name. The file will be
namedT72XW_nn where "nn" can be a number between 01 and 99. Enter the desired file number
then press ENTER.
4 Focus will move to the Start prompt on the display. Press ENTER to begin the backup or
press the LEFT navigation key to exit without saving.
5 After pressing ENTER, the terminal will indicate Working. Please wait. during the backup
and Backup complete when the backup procedure is finished.
6 Press ENTER to acknowledge the Backup complete message then exit setup.
2.11

Restore from SD Memory Card

After the setup parameters have been stored onto the SD memory card, they can be restored to
the terminal when needed by following this procedure.

After a restore is performed, the system will automatically restart.
1 Remove power from the terminal and insert the SD memory card if not already installed. Refer to
Figure 2-7 for location of SD memory card.
2 Apply power, enter setup and access the restore procedure at Maintenance > Restore from SD.
Ohaus Corporation www.ohaus.com
Figure 2-7: Inserting the SD Memory Card
2-12 7000 Series T72XW Indicators Service Manual