Lincoln Electric IDEALARC DC-1500 Service Manual page 97

G-4
pc BOarD aSSEmBlY - cONTrOl pc BOarD - (G1530-2)
ENGINEERING CONTROLLED
MANUFACTURER:
N.F. A FT ER P. C. B OARD TEST I S COMPLETED, S EA L R 63 WITH .375 WID E E 1058 TAP E.
FOR PARTS ORDERS:
SEAL TRIMM ER WITH A DROP OF E4018.
INCLUD E S17710 INSTRUCTION D EC AL
NOTE: Lincoln Electric assumes no responsibility for liablilities resulting from board level troubleshooting. PC Board repairs will invalidate your factory warranty. individual printed circuit Board components are not available from lincoln Electric. This information is pro-
vided for reference only. Lincoln Electric discourages board level troubleshooting and repair since it may compromise the quality of the design and may result in danger to the Machine Operator or Technician. Improper PC board repairs could result in damage to the
machine.
ElEcTrical DiaGramS
DZ1, MANUFACTURED AS AND IDENTIFICATION CODE, REVISED PART NUMBER.
CHANGE DETAIL:
No
5
4
N.C., N.F.
PRO PRIETARY & C ONFIDENTIAL: THIS DOCUMENT CONTAINS PROPRIETARY INFORMATION OWNED BY LINCOLN GLOBAL, INC. AND MAY NOT BE DUPLICATED, COMMUNICATED
TO OTHER PARTIES OR USED FOR ANY PURPOSE WITHOUT THE EXPRESS WRITTEN PERMISSION OF LINCOLN GLOBAL, INC.
MANUF ACTURING TO LERANCE PER E2056 SCALE:
CONTROL: CLEVEL AND EQUIPM ENT TYPE: IDEALA R C D. C. 1500
UNLESS OTHERWISE SPECIFIED TOLERANCE:
ON 2 PLACE DECIMALS I S ± .02 in. ( ± 0.5 mm)
NONE
DRAWN BY:
ON 3 PLACE DECIMALS IS ± .002 in. ( ± 0.05 mm) fivory
IF PRINTED SUBJECT: CONTR OL P.C. BOA R D ASSE MBLY
ON A LL AN GL ES IS ± .5 OF A DEGREE
@ A1 SIZE
MATERIAL TOLERANCE (" ") TO AGREE t ENGINEER: -
WITH PUBLISHED STANDARDS. UNITS: MATERIAL REFERENCE:
APPROVAL PROJECT CRM42848
UF 4/23/2010
DO NOT SCALE THIS DRAWING APPROVED: BS INCH DISPOSITION: DATE: NUMBER:
iDEalarc® Dc-1500
G-4
K
58
6
K
1 1
PAGE ___ OF ___
DOCUMENT
DOCUMENT
NUMBER: REVISION:
G1530-2
F
-