Horizontal Adjustments - Baker A User Manual

Horizontal Adjustments

 With the vertical alignment set correctly, compare the blade's position at the top and
bottom to its position on the left side of the wheel. If it is not the same, proceed to the
next step.
 If the left side of the wheel needs to go "back," turn the horizontal adjuster bolt clockwise.
If the left side of the wheel needs to come forward, turn the horizontal adjuster bolt
counter-clockwise.
 Of course, you'll need to loosen the lock nut first. And, don't forget to retighten the lock
nut when finished adjusting.
 Manually turn the wheel several rotations counterclockwise and check the tracking as in
first step above. If horizontal tracking is still not correct, repeat procedure until blade
position on the left side of wheel is the same as the top and bottom. Do the same after
rotating the wheel clockwise.
Horizontal Adjuster Bolt
Figure D: Top View of Idler Wheel with Cover Removed
Effect of Horizontal Adjuster
20