Feedworks; Feed Speed; Hydraulics - Baker A User Manual

FEEDWORKS

Feed Speed

When the Feed works Start/Stop Knob is pushed down, the Feed works is stopped. To start
the Feed works, pull the knob up.
Note: Always make sure the Feed works Start/Stop Knob is down (off) when starting the
saw.
The feed speed can be adjusted from 20 to 120 feet per minute with the Feed Speed Control
Arm located on the backside of the head rig. When the arm is pointed down, the Feed works
should be motionless. As you swing the arm up, the feed speed will increase. The arm can
be locked into place with the knob located on the arm. Make sure this knob is loosened
when you wish to move the arm. You will want to experiment to find the best speed to run
your wood types.
Hydraulic Fluid Reservoir

Hydraulics

The Feed works uses a hydraulic pump driven off of the main drive motor. Dextron III
Transmission fluid is recommended.
Feed Speed
Control Arm
Figure J: Feedworks Assembly
25
Hydraulic Fluid Filter
Feedworks Start/Stop