Table of Contents
Advertisement
BLADES
The standard Baker "A" uses the following blades:
13' – 2" x 1" x .035 2T Woodmaster C Band Blades
The standard Baker "AX" uses the following blades:
14' – 2" x 1" x .035 2T Woodmaster C Band Blades
NOTE: 1-1/4" guide plates as well as other blade widths; thickness and tooth spacing are
available upon request.
Ask your sales consultant or the customer service department for details.
Blade usage is approximately two blades per day per head during full production. Use this
figure when ordering your blades until you have developed some record of blade usage for
your operation.
Using high quality blades is an important factor in achieving the highest performance out of
your Baker A/AX band resaw. Our machines are tested and set-up using Lenox blades sold
by Ellington Industrial Supply. These are very good blades for use on the Baker and come
highly recommended by the majority of Baker owners. If you would like more information on
these blades, contact:
Customer Service Department
Ellington Industrial Supply Co., Inc.
PO Box 128
Ellington, MO 63638 USA
Tel: (573) 663-7711
Fax: (573) 663-2787
16
Advertisement
Table of Contents
