Assembly; Operation - Flex LW 1503 Instruction Manual

Instruction manual

Assembly

Attaching the handle
A handle (H) Fig. 1 is furnished with your
tool. This handle SHOULD BE USED AT
ALL TIMES to maintain complete control
of the tool.
1
Install polishing wheel
CAUTION
Disconnect tool from power source.
1. Rest machine on its back with
spindle facing up.
2. Position polishing wheel to spindle
shaft.
2
3. Thread wheel to spindle shaft (W)
Fig. 2, hand tight.
10

Operation

Connection to the power supply
with gfci switch
DANGER
This tool is provided with a Ground
Fault Circuit-Interrupter (GFCI). Never
use the tool without the GFCI installed
and working properly. Before using the
tool TEST the GFCI device.
CAUTION
Make sure switch is OFF and power
circuit voltage is the same as that
shown on the specification plate.
Always check the machine before use:
1. Insert the mains plug into the socket.
3
2. Press "RESET" button. The red
indicator light must come on.
3. Press "TEST" button.
The PRCD switch must switch off
and the indicator light go out.
4. When the "RESET" button is
pressed again, it must be possible to
switch on the power tool.
LW 1503