Tips For Charging The Device; Device Care; Cleaning The Device; Changing The Bands - Garmin FORERUNNER 55 Owner's Manual

Tips for Charging the Device

1 Connect the charger securely to the device to charge it using the USB cable
You can charge the device by plugging the USB cable into a Garmin approved AC adapter with a standard
wall outlet or a USB port on your computer. Charging a fully depleted battery takes up to two hours.
2 Remove the charger from the device after the battery charge level reaches 100%.

Device Care

Avoid extreme shock and harsh treatment, because it can degrade the life of the product.
Avoid pressing the keys under water.
Do not use a sharp object to clean the device.
Avoid chemical cleaners, solvents, and insect repellents that can damage plastic components and finishes.
Thoroughly rinse the device with fresh water after exposure to chlorine, salt water, sunscreen, cosmetics,
alcohol, or other harsh chemicals. Prolonged exposure to these substances can damage the case.
Do not store the device where prolonged exposure to extreme temperatures can occur, because it can cause
permanent damage.

Cleaning the Device

Even small amounts of sweat or moisture can cause corrosion of the electrical contacts when connected to a
charger. Corrosion can prevent charging and data transfer.
1 Wipe the device using a cloth dampened with a mild detergent solution.
2 Wipe it dry.
After cleaning, allow the device to dry completely.
TIP: For more information, go to www.garmin.com/fitandcare.

Changing the Bands

The device is compatible with 20 mm wide, standard, quick-release bands.
1 Slide the quick-release pin on the spring bar to remove the band.
2 Insert one side of the spring bar for the new band into the device.
3 Slide the quick-release pin, and align the spring bar with the opposite side of the device.
4 Repeat steps 1 through 3 to change the other band.
Device Information
NOTICE
NOTICE
(Charging the Device, page 46).
47