GE Multilin 350 Series Instruction Manual page 65

CHAPTER 3: INTERFACES
350 FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL
Courtesy of NationalSwitchgear.com
3. The EnerVista SR3 Setup software will request the new firmware file. Locate the folder
that contains the firmware files to load into the 350. The firmware filename has the
following format:
L0 L01 M A 140 . 000
4. EnerVista SR3 Setup software now prepares the 350 to receive the new firmware file.
The 350 front panel will momentarily display "SR BOOT PROGRAM Waiting for
Message," indicating that it is in upload mode.
5. While the file is being loaded into the 350, a status box appears showing how much of
the new firmware file has been transferred and the upgrade status. The entire transfer
process takes approximately 10 minutes.
6. The EnerVista SR3 Setup software will notify the user when the 350 has finished
loading the file. Carefully read any displayed messages and click OK to return the
main screen. Cycling power to the relay is recommended after a firmware
upgrade.
Modification Number (000 = none)
Firmware Rev #
Board Assembly Rev #
Code Type in Memory Device
PCB Code Number
Product Reference Code (L0 = 350)
SOFTWARE SETUP
3–25