GE Multilin 350 Series Instruction Manual page 52

SOFTWARE SETUP
3–12
Courtesy of NationalSwitchgear.com
If you are going to communicate from your computer to the 350 Relay using the USB
port:
10. Plug the USB cable into the USB port on the 350 Relay then into the USB port on your
computer.
11. Launch EnerVista SR3 Setup from LaunchPad.
12. In EnerVista > Device Setup:
13. Select USB as the Interface type.
14. Select 350 Relay as the USB device.
CHAPTER 3: INTERFACES
350 FEEDER PROTECTION SYSTEM – INSTRUCTION MANUAL