Fike FIK-RA100BD Product Installation Document
Fike FIK-RA100BD Product Installation Document

Fike FIK-RA100BD Product Installation Document

Replacement annunciator board

Advertisement

FIKE CORPORATION
704 SW 10th Street
Blue Springs, MO 64015
www.fike.com
1

Description

The FIK-RA100BD is the replacement annunciator board used with the Fike Series, ECS System. The FIK-RA100BD is housed in the Fike
Series, ECS fire alarm control panel (FACP) cabinet. The FIK-RA100BD is housed in the FIK-RA100 remote annunciator cabinet.
NOTE: The installation and wiring of this device must be done in accordance with the NFPA 72 and the local ordinances.

1.1 Compatibility

The FIK-RA1000BD is compatible with the Fike Series, Fire Alarm Control Panels (FACPs).
NOTE: For more information, see the FACP Installation Manual.

1.2 Specifications

Standby Current:
Alarm Current:
Operating Voltage:
Operating Temperature: 32°F to 120°F (0°C to 49°C)

2 Mounting

1.
Remove the AC power from the ECS FACP.
2.
Open the cabinet to access the annunciator board.
3.
Remove the FIK-RA100 from its mounting location as shown in Figure 1.
4.
Install the new annunciator board.
20 mA
25 mA
24VDC
Figure 1 FIK-RA100 Mounting Screws
FIK-RA100BD
Product Installation Document
PN LS10260-001FK-E:A 03/03/2021 ECN: 151526

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FIK-RA100BD and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Fike FIK-RA100BD

  • Page 1 Description The FIK-RA100BD is the replacement annunciator board used with the Fike Series, ECS System. The FIK-RA100BD is housed in the Fike Series, ECS fire alarm control panel (FACP) cabinet. The FIK-RA100BD is housed in the FIK-RA100 remote annunciator cabinet.
  • Page 2 4 Programming The FIK-RA100BD must have the dip switches set to match the existing FIK-RA100BD, if possible. See Figure 3 for the device IDs and the corresponding dip switch settings. If you match the existing device ID, you need to program the new FIK-RA100BD. If you use a different device ID, you must program the FIK-RA100 into the Fike, ECS FACP.

Table of Contents