Omron sysmac NJ Series Connection Manual page 21

Machine automation controller, displacement sensor

Hide thumbs Also See for sysmac NJ Series:

Table of Contents

7.2.2.

Parameter Settings

Set the parameters for Sensor Controller.

The parameters are set using Sysmac Studio.

Install Sysmac Studio on Personal computer beforehand.

Since Personal computer and Sensor Controller are connected with LAN cables, set the IP

address of Personal computer to 192.168.250.100.

Precautions for Correct Use

The Parameters for Sensor Controller are checked using Ethernet communications with

Personal computer.

Note that there may be some changes required for the Personal computer settings

depending on the state of Personal computer.

Turn ON Sensor Controller and

Switching hub.

7．EtherNet/IP Connection Procedure

Table of Contents