Connecting The Unit To An Internal Computer Network Or The Internet - Komfovent DOMEKT C8 Installation Manual

It is advisable to run the control panel cable in such a way that it does not go near the power supply wires or high volta-
ge electrical equipment (electrical inlet cabinets, electric water heating boiler, air conditioning unit, etc.). The cable can be
passed through the holes in the back or bottom of the control panel (follow the installation instructions supplied with the
control panel). The wire to C8 controller board is connected to a dedicated slot (RJ9 connector; see Fig. 10) or to the terminals
for external connections.
Do not use sharp tools (e.g. screwdriver) to press on the control panel's contacts. Pencil or ballpoint pen
is best for this.

4.4. Connecting the unit to an internal computer network or the Internet

The unit can be controlled not only by the control panel, but also by computer or smart phone. In such cases, the air
handling unit must be connected to an local computer network or to the Internet. The unit is controlled by a computer using
a web browser, or a smartphone with a Komfovent Home or Komfovent Control app. The air handling unit is connected to
the computer network with a CAT5 type cable (RJ45 connector; see Fig. 10). The total cable length between the unit and the
network router must not exceed 100 m.
By default, the IP address of the air handling unit is 192.168.0.60, but it can be changed (if necessary) according to the
local network parameters. The IP address can be found and changed on the control panel
16:30
NORMAL
ECO AUTO
Fig. 16. View and change the IP address of the AHU on the control panel
Only on the C6.1 panel (see Fig. 19).
1
UAB KOMFOVENT we reserve the right to make changes without prior notice
DOMEKT_C8_21-01
Y e ll o
w (A
)
G re e
n (B )
( ) W
h it e
(+ ) R
e d
Fig. 15. Cable connection to the control panel
Menu
Temperature control
Overview
Air quality control
Scheduling
Fire dampers
Control sequence
Settings
5 s
TURN OFF
Yellow (A)
Advanced settings Advanced settings
Connectivity
Clean filters calibration
Komfovent Control
1 / 2
Reset settings
Reset settings
.
1
Connectivity
DHCP
IP address
192.168.0.60
Subnet mask
255.255.255.0
Gateway
192.168.0.1
BACnet ID
2 / 2
60
( ) White
(+) Red
25