Assembly And Installation - pro.point 8678963 User Manual

V1.0
IDENTIFICATION KEY
A Rubber Sanding Drum
B Sanding Sleeve
C Dust Collection Port, 2-1/2 in.
(Not Visible)
D ON/OFF Switch
E Spindle, Upper Washer and
Lock Nut
F Working Table
G Sanding Drum Storage Pegs
H Table Insert
I Rubber Drum Storage (at Rear of Base)
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included
Parts List. Letter references in parenthesis (A) refer to the
included Identification Key.
MOUNT TOOL ON A PEDESTAL
The hardware to mount tool is not included. The pedestal must be
secured to the floor to prevent it from tipping over.
1. Align the tool's mounting holes with the corresponding
pedestal holes.
2. Slide a flat washer over a 1/4-20 x 1 in. hex head bolt and
insert through the grinder base and pedestal holes.
3. Slide a 1/4 in. flat washer over the end of the bolt and screw
a 1/4-20 in. hex nut onto the bolt end. Tighten until the
space between the tool's base and pedestal is 1/8 in.
4. Screw a second nut onto the bolt and secure against
the first. This will prevent them from loosening due to
the tool's vibration.
5. Repeat steps 1 to 4 for the other three bolt holes.
Visit www.princessauto.com for more information
SPINDLE SANDER 8678963
Fig. 1
9