Table of Contents
Advertisement
Chapter 2. Installation
INSTALLING THE NXT1 HSSI/V.35 MODULE
To ensure that the thumbscrews are securely fastened, use a screwdriver to tighten them.
24
Figure 2-1 represents the actions required to properly install the
NxT1 HSSI/V.35 Module, as described in the Step/Action table below.
Figure 2-1. Installing the NxT1 HSSI/V.35 Module
Instructions for Installing the NxT1 HSSI/V.35 Module
Step
Remove the cover plate from the appropriate option slot in the
1
ATLAS 800 Series chassis rear panel.
Slide the NxT1 HSSI/V.35 Module into the option slot until the
2
module is firmly positioned against the front of the chassis.
3
Secure the thumbscrews at both edges of the module.
4
Connect the cables to the associated device(s).
Complete installation of remaining modules and Base Unit as
5
specified in the Installation chapter of the ATLAS 800 Series
User Manual.
NxT1 HSSI/V.35 User Manual
Action
61200771L1-1
Advertisement
Table of Contents
