Operation; Commissioning; Functional Description - Judo EASY FILT-B Installation And Operating Instructions Manual

5.

Operation

ATTENTION
(see chapter "Safety
dangers due to non-compliance")
Always observe the chapter "Intended use"!
5.1

Commissioning

Before starting up (initial putting into service
or startup after maintenance work), the filter
must be filled with water and vented!
– To this end, after installation the filter is
filled with water by opening the upstream
shut-off valve.
The filter is now at the same pressure as the
water system.
– The enclosed air must then be imme-
diately removed from the filter in order to
avoid damage to the installation caused
by pressure surges. The filter is vented
by means of backwashing (see chapter
"Backwashing").
After backwashing and venting the filter is
ready for use.
5.2

Functional description

The unfiltered water flows through the built-
in rotary flange (1) into the filter. The water
flows through the fine filter from the outside
inwards. The filtered dirt is retained by the
fine filter screen. The adhering dirt is visible
through the transparent filter cover (5). The
filtered water then leaves the filter via the
built-in rotary flange (1).
10
Operation
information and
JUDO EASY FILT-B
1
7
8
9
Fig. 5: Functional description
1 Built-in rotary flange
2 Display button
3 Flange cover
4 Strainer
5 Filter cover
6 Suction pipe
7 Flushing valve
8 Handwheel for free discharge
9 Rotatable hose connection for
backwashing water
2
3
1
4
5
6