Notes On Special Dangers; Product Information; Intended Purpose; Materials Used - Judo EASY FILT-B Installation And Operating Instructions Manual

Backwash protective filter
Table of Contents

Advertisement

Available languages

Available languages

The installation of a pressure reduc-
tion valve is recommended for
water pressures between 5 bar
and 10 bar.
2.2

Notes on special dangers

2.2.1 Electrical equipment /
installations
There must not be any electrical
cables and devices underneath or in
the immediate vicinity of the filter!
Electrical devices / equipment that are not
splash-water proof and are situated in the
direct vicinity of the filter may be damaged
by water leaking from the filter caused as a
result of the device not being operated in
accordance with the manufacturer's specifi-
cations.
In addition this may also result short circuits
if these electrical devices / equipment being
connected to the electrical power supply. In
the event of such cases persons are at risk
and may sustain electrical shocks. There-
fore any electrical devices / equipment situa-
ted in the direct vicinity should be splash-
water proof, respectively comply with the
statutory requirements for wet areas (IP44).
6

Product information

3.
Product information
3.1

Intended purpose

This filter is suitable for use in cold drinking
water up to a water temperature of
maximum 30 °C (86 °F).
ATTENTION
(see
chapter
dangers due to non-compliance")
Please refer to the chapter on "Intended
use" for use restrictions.
This filter removes coarse and fine-grained
particles from the water which are larger
than or equal in size to the mesh size of the
filter.
3.2

Materials used

The materials used are resistant to the
physical, chemical, and corrosive loads to
be expected in the drinking water and fulfil
the requirements specified in the DIN EN
13443-1
("Mechanical filters in drinking water instal-
lations"). All materials are hygienically and
physiologically safe. Plastics fulfil the official
guideline of the German Federal Environ-
mental Agency as well as the DVGW work
sheet W 270. Metallic materials fulfil the
requirements of the DIN 50930-6 standard
(Impact on the drinking water quality).
JUDO EASY FILT-B
"Safety
information
Particles smaller than the supplied
mesh size and impurities causing
turbidity cannot be filtered out of the
water.
and
DIN
19628
and
standards

Advertisement

Table of Contents
loading

Table of Contents