General Maintenance Information; Maintenance Schedule - Krautzberger MP-400 Operating Instructions Manual

CAUTION!
Risk of injury due to sharp edges!
Sharp edges and pointed corners can cause abrasions and cuts on the skin.
Note:
– Proceed cautiously when working on or near sharp edges and pointed corners.
– Wear protective gloves, if in doubt.
8.2

General maintenance information

Even with intended use by environmental influences, the service life of hose lines and pipelines is
limited. As a preventative measure, all hose lines and pipelines should be replaced regularly in
accordance with their load.
The following sections describe the maintenance work that is required for optimal and fault-free
operation of the device.
Check wearing parts such as seals at regular intervals. The level of wear depends on the abrasive-
ness of the spray fluid used. Escaping air and spray fluid are signs that parts are worn. In case of
questions about maintenance work and intervals, contact the manufacturer; see contact informa-
tion on the last page.
8.3

Maintenance schedule

Interval
Prior to each work process
Before performing any mainte-
nance work
Prior to every long-term shut-
down
When necessary
GB–32
Operating instructions
Maintenance work
Check the material or compressed air lines to make sure they
are undamaged and have a secure fit
Clean diaphragm pump (
pump' on page 33)
Clean diaphragm pump (
pump' on page 33)
Replace valve parts (
on page 34)
Replace diaphragm (
on page 36)
Ä Chapter 8.4 'Clean the diaphragm
Ä Chapter 8.4 'Clean the diaphragm
Ä Chapter 8.5 'Replace valve parts'
Ä Chapter 8.6 'Replace the diaphragm'
mail@krautzberger.com, www.krautzberger.com
T-Dok-236-GB-Rev.1