8.6
Replace the diaphragm
The following is a description of how to replace diaphragm using the example of the left-hand
side of the diaphragm pump.
1.
Clean diaphragm pump (
2.
Make sure that the compressed air supply is switched off and secured against a restart.
3.
Reduce the fluid pressure by activating the extraction point.
Fig. 12: Unscrew the cover
4.
Unfasten all 4 screw ( Fig. 12/1) and remove the cover ( Fig. 12/2).
Fig. 13: Unscrewing the diaphragm
5.
Unscrew the diaphragm ( Fig. 13/3) from the control pin ( Fig. 13/2).
GB–36
Operating instructions
Ä Chapter 8.4 'Clean the diaphragm pump' on page 33).
T-Dok-236-GB-Rev.1
mail@krautzberger.com, www.krautzberger.com