Table 3-2 Collecting Fault Information About The Gpon Service - Huawei EchoLife HG861 Manual

3 Configuration Guide

Table 3-2 Collecting fault information about the GPON service

Num
ber
1
2
3
4
3-8
Item Collecting Method
Run the following commands in the global config mode:
l
Running status of
l
the board
NOTE
Run the following commands in the GIU mode:
l
l
Upstream port
information of the
l
host
l
NOTE
Run the following command in the global config mode:
display service-port port frameid/slotid/portid
Run the following commands in the GPON configuration
mode:
Service virtual port
l
information of the
l
host
l
NOTE
Record the version information about the ONT and status of
each LED.
Run the following commands in the GPON configuration
mode:
l
l
l
ONT information
l
l
l
l
l
NOTE
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
display board frameid/slotid
display version frameid/slotid
This command is applicable to only the ONTs of the V800R005 and
V800R006C02 versions in the distributed mode at the CO end.
display port state
display port statistics
display port opticstate
display port traffic
This command is applicable to only the ONTs of the V800R005 and
V800R006C02 versions in the distributed mode at the CO end.
display port info
display port state
display port ont-regiser-info
This command is applicable to only the ONTs of the V800R005 and
V800R006C02 versions in the distributed mode at the CO end.
display ont info
display ont version
display ont state
display gemport
display ont gemport
display ont gemport mapping
display ont capability
display ont port vlan
This command is applicable to only the ONTs of the V800R005 and
V800R006C02 versions in the distributed mode at the CO end.
EchoLife HG861 GPON Terminal
Issue 01 (2009-07-30)