Electrical Safety - Black & Decker CP310X Manual

CHARGERS
Use your Black & Decker charger only to charge the
•
battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and
damage.
Never attempt to charge non-rechargeable batteries.
•
Have defective cords replaced immediately.
•
Do not expose the charger to water.
•
Do not open the charger.
•
Do not probe the charger.
•
The charger is intended for indoor use only.
Read the instruction manual before use.
The charger automatically shuts off if the ambient
temperature becomes too high. As soon as the
ambient temperature has cooled down, the charger
will resume operating.
Charge only at ambient temperatures between
10 °C and 40 °C.
Charging

ELECTRICAL SAFETY

Your charger is double insulated; therefore no earth
wire is required. Always check that the mains
voltage corresponds to the voltage on the rating
plate. Never attempt to replace the charger unit
with a regular mains plug.
If the supply cord is damaged, it must be replaced by
•
the manufacturer or an authorised Black & Decker
Service Centre in order to avoid a hazard.
Warning! Never attempt to replace the charger unit with
a regular mains plug.
FEATURES
1. On/off switch
2. Forward/reverse slider
3. Bit holder
4. LED light
7. Charger connector
FIG. A
5. Charger
6. Charger plug
ASSEMBLY
FITTING AND REMOVING A DRILL BIT OR
A SCREWDRIVER BIT (fig. B)
This tool uses screwdriver bits and drill bits with
a 6.35 mm (1/4") hexagonal shank.
To fit a bit, insert the bit shaft into the bit holder (3).
•
To remove a bit, pull the bit shaft out of the bit
•
holder (3).
USE
Before first use, the battery must be charged for at
•
least 12 hours.
The battery needs to be charged before first use and
•
whenever it fails to produce sufficient power on jobs
that were easily done before. When charging the
battery for the first time, or after a prolonged storage,
it will only accept an 80% charge. After several
charges and discharge cycles, the battery will attain
full capacity.
CHARGING THE BATTERY (FIG. C)
To charge the battery, insert the charger plug (6) into
•
the charger connector (7).
Plug in the charger (5).
•
Leave the tool connected to the charger for 16 hours.
•
The charger may hum and become warm while
charging; this is normal and does not indicate
a problem.
Warning! Do not charge the battery at ambient
temperatures below 10 °C or above 40 °C.
SELECTING THE DIRECTION OF ROTATION
(FIG. D)
For drilling and for tightening screws, use forward
rotation. For loosening screws or removing a jammed
drill bit, use reverse rotation.
To select forward rotation, push the forward/reverse
•
slider (2) to the forward position.
To select reverse rotation, push the forward/reverse
•
slider (2) to the rearward position.
To lock the tool, set the forward/reverse slider into the
•
centre position.
DRILLING/SCREWDRIVING
Select forward or reverse rotation using the forward/
•
reverse slider (2).
To switch the tool on, press the on/off switch (1).
•
To switch the tool off, release the on/off switch (1).
•
LED LIGHT
The LED light (4) is activated automatically when the
trigger is depressed. The LED will also illuminate when
the trigger is depressed and the forward/reverse slider (2)
is in the locked off position (central position).
Hints for optimum use
SCREWDRIVING
Let the tool work at its own pace. Do not overload.
•
Always use the correct type and size of screwdriver
•
bit.
ENGLISH
5