Maintenance - YASKAWA EcoTrim ET-1024 System Manual

175932-1CD
EcoTrim ET-1024 System
5

Maintenance

5 Maintenance
Maintenance of the EcoTrim ET-1024 System and components must be
performed by authorized personnel who are familiar with the EcoTrim ET-
1024 System. Perform the procedures given in this section as needed. Be
sure to read and understand the documentation for a particular
component before doing repair or preventive maintenance on that
component. Be sure that you understand the maintenance procedures,
have the proper tools at hand, and comply with all safety instructions and
precautions given throughout this manual.
Be advised that the maintenance intervals given in Table 5-1 are
recommendations only. Adjust the frequency and level to suit your specific
equipment schedules and shop environment.
For periodic maintenance procedures and schedules for the individual
components of your EcoTrim ET-1024 System, refer to the documentation
that is included with your EcoTrim ET-1024 System (refer to section 1.3).
Table 5-1: Periodic Maintenance
FREQUENCY COMPONENT
Daily All safeguard items –
work-cell door interlocks,
E-STOP push buttons,
safety light curtains, etc.
Monthly EcoTrim ET-1024 System
Work Cell
5-1
PROCEDURE
Check the physical condition of
the safeguard item and ensure
that the safeguard item is
working correctly.
Remove accumulated dirt,
grease, and debris from inside
and outside the work cell.
175932-1CD
53 of 64