Table of Contents
Advertisement
Installation Guide
90cm freestanding cookers
WIRING REQUIREMENTS
The cooker MUST be installed in compliance with:
• Wiring connections in AS/NZS 3000 Wiring Rules.
• Local regulations, municipal building codes and other statutory
regulations.
For New Zealand Only:
The cooking range must be connected to the supply by a
supply cord fitted with the appropriately rated plug that is
compatible with the socket-outlet fitted to the final sub-
circuit in the fixed wiring that is intended to supply this
cooking range.
Supply cord size required:
WFE904/WFE915/WFE916 models - 2.5mm
WFEP917 models - 4.0mm
WFE946 models - 6.0mm
The Data plate gives information about rating and is located behind
the bottom of the oven door.
• A functional switch MUST be provided near the appliance in an
accessible position (AS/NZS 3000 - Clause 4.7.1).
• Wiring MUST be protected against mechanical failure (AS/NZS
3000 - Clause 3.9).
• Disconnection in the fixed wiring must occur in accordance with
the AS/NZS 3000 wiring rules.
• The cooker MUST be properly earthed.
• This range must be connected with cable of 75°C rating minimum.
• This product has passed the insulation resistance test after
manufacture. If the resistance reading is low at installation, it
is probably caused by moisture from the atmosphere being
absorbed by the elements after the range has been produced.
(pass at 0.01 M AS/NZS 3000 Wiring Rules Clause 8.3.6.3).
Note: When connections are made to a multi-phase 230/240V
supply, the bridge piece MUST be removed from between the active
connections.
Rated power input
MODEL
TOTAL KW
WFE946
13.1
TIPS & INFORMATION
IMPORTANT
Before you cook in your new oven it is important that the protective
oils used in the manufacture of the product be removed.
• Make sure that the room is well ventilated (to allow smoke to
escape).
• Run the grill on high for 30 minutes without grill dish.
• Then run the oven on 180°C for 1 hour.
6
2
2
2
A1 KW
A2 KW
3.6
9.5
Connecting to services and commissioning
This appliance must be installed by an authorised person, according
to all codes and regulations of:
• Electrical supply authorities.
• Building regulations.
• Local government and council authorities.
• AS/NZS5601.1 (particular attention to 6.10.1 and figure 6.3, and
clause 6.10.1.11).
• AS/NZS 3000 (particular attention to clause 4.7.1
and clause 3.9).
Hard wiring detail
1. Remove terminal cover plate from rear panel of appliance.
2. Fit wires through hole in cover plate and make connections to
terminals.
3. Engage wires into plastic clip. Secure plastic clip with two long
silver screws (supplied in separate bag).
4. Replace cover plate onto rear panel.
GAS REQUIREMENTS
Gas hose restraints
point to regulator
Gas connection point
to regulator
168
Plastic clips
Plastic clip
Securing points
Electrical cable
entry point
95
Advertisement
Table of Contents
