Westinghouse WFE946 Installation Manual page 3

Levelling oven
Place a level in the oven as below making sure the level sits on the
front and rear forms. Adjust the feet accordingly to level the appliance.
Installing splashback
Fit splashback to rear of hob with three screws provided.
INSTALLATION OF ANTI-TILT
BRACKET
To ensure cooker stability, the anti-tilt brackets must be installed.
There are left and right engagement slots for the anti-tilt bracket
at the bottom rear of the appliance. The following steps must be
followed to ensure the correct installation of anti-tilt brackets and
the stability of the appliance.
CAUTION WARNING
It is not recommended to push and pull the appliance on uneven
or rough surface. Use other means to manoeuvre the appliance if
necessary.
1. Carefully push the appliance into the cabinet cavity until the back
of the oven is flush against the back wall.
2. Use non-permanent methods to mark a line on the wall along the
top surface of the splashback. This line is used as a reference line
to locate the correct location of where the anti-tilt brackets need
to be installed.
3. After the reference line is marked, pull the appliance out of the
cabinet cavity to install the anti-tilt brackets.
WARNING
WARNING
• Appropriate fasteners must be used to suit the type of wall on
which the anti-tilt brackets are installed.
• Freestanding unit must be pushed up against the wall on
installation. On gas units check that the gas hose, if used,
has not been kinked during installation.
4. The anti-tilt brackets must be secured to the rear wall of the cavity
with appropriate fasteners according to dimensions in diagram.
Anti-tilt bracket
installation
reference line
Freestanding installation checklist
 Connect services to the appliance prior to placing into cavity.
 To locate appliance, slide into cavity ensuring the anti-tilt brackets
fully engaged with the rear left and right engagement slots.
 The unit must be pushed against the wall on installation.
 Re-install oven door, burner body, burner caps and trivets after the
appliance is placed in the cavity.
 Gas only: check that the gas hose, if used, has not been kinked
during installation
Anti-tilt bracket installation
reference line
C
L
425
370 370
Install anti-tilt
brackets in
this orientation
as shown
(fasteners not
supplied)
3