Table of Contents
Advertisement
Unpacking and Installation
12
Shipping Carton
This should be inspected upon delivery. When received,
carefully examine for any shipping damage before
unpacking. If damage is discovered, the delivering carrier
should both specify and sign for the damage on your copy
of the delivery receipt.
Open the carton carefully making certain that all parts are
accounted for before packaging materials are discarded.
After unpacking, if damage is found, promptly report it to
the carrier and request a damage inspection promptly.
IMPORTANT: Failure to request an inspection of
damage within a few days after receipt of shipment
absolves the carrier from any liability for damage. You
must call for a damage inspection promptly.
Unpacking
Use the list below when unpacking to verify that the
complete unit has been received. Do not discard packing
materials until all is accounted for.
The following items are included in the shipment:
Refrigerator/Freezer
Operation Manual
Volt Warning Tag
240V Registration Card
Inspection Tag
Location
Place the unit on a floor that is strong enough to support
the unit when it is fully loaded. To level the unit, adjust the
leveling legs at the bottom. To level the unit, the leveling
legs can be either turned clockwise to raise that side of
the unit, or turn counter-clock wise to lower that side.
Locate the unit away from direct sunlight and sources of
heat(heater etc.)Locate the unit in most convenient place
and near a grounded electrical outlet.
Clearance
For 02LREETSA
Allow 4" of space on the sides and the same amount of
space between the back and the wall. Allow at least
1.25" above the top of the unit.
For 05EFEETSA, 05FFEETSA, 05LFEETSA models:
Allow 1" of space on the sides and the same amount of
space between the back and the wall. Allow at least 4
inches above the top of the unit.
Advertisement
Table of Contents
