Installation
4.3.4
Mounting the Magnet Assembly to the Friction Basket Assembly
1. Orient the magnet as desired with the lifting tab at the top or bottom.
2. Slide the magnet assembly onto the six studs of the friction brake assembly until the
magnet contacts the friction brake.
3. Place the flat washers onto the studs and start each of the six lock nuts.
4. Using a 17mm wrench, tighten the lock nuts equally in stages, reducing the air gap of the
magnet to approximately 2mm.
•
2020 KEB America, Inc.
©
Figure 8 Mounting the Magnet Assembly
The air gap will be adjusted more precisely in the next section.
i
It may be easier to tighten the nuts three at a time to ensure the
magnet remains flat in relation to the friction brake assembly.
25