Installation; Figure 19 Enclosure Assembly; Figure 20 Gasket Installation; Figure 21 Gasket End - KEB COMBISTOP 38 Instruction Manual

Optional Components and Accessories
5.4.1

Installation

1. Peel the backing from the gasket and insert into the grove on the Theater Load Brake
flange.
2. Overlap the finished end of the gasket over the beginning and cut through both with a
knife at a diagonal angle.
3. Remove the loose ends and press the gasket ends together while pressing down, as
shown below.

Figure 20 Gasket Installation

4. Screw the M8 standard nuts 12mm onto the M8x80 enclosure studs.
5. Screw the studs into the back of the magnet about 10mm deep.
6. Tighten the nuts against the magnet as shown below.
2020 KEB America, Inc.
©

Figure 19 Enclosure Assembly

Figure 21 Gasket End

35