Figure 22 Mounting The Enclosure Studs; Figure 23 Enclosure Plugs - KEB COMBISTOP 38 Instruction Manual

Optional Components and Accessories
7. Insert the plugs into the holes on the enclosure that will not be used for wire ingress.
•
8. Install the customer supplied glands into the enclosure holes that will be used for wire
ingress.
9. Run wires through the glands for power and Microswitch (if installed).
10. Place the enclosure onto the magnet studs as shown below.
36

Figure 22 Mounting the Enclosure Studs

Four holes are provided for ¾'' connection fittings.

Figure 23 Enclosure Plugs

2020 KEB America, Inc.
©