Installation; Figure 11 Removing The Manual Release Bolts; Figure 12 Mounting The Hand Release Yoke - KEB COMBISTOP 38 Instruction Manual

Optional Components and Accessories

5.2 Installation

1. Using a 19mm wrench/socket, remove the two manual release bolts from the magnet
assembly as shown above.
2. Remove the lifting tab or move it to storage position if the lifting tap is still in the
installation position.
•
3. Mount the hand release yoke to the magnet using the included bolts and washers as
shown below.
4. Tighten the bolts to 80Nm with a 15mm wrench/socket.
5. Screw the hand release handle to the yoke, ensuring a tight fit.
2020 KEB America, Inc.
©

Figure 11 Removing the Manual Release Bolts

The lifting tab will interfere with the operation of the Hand Release Lever if left in
installation position.

Figure 12 Mounting the Hand Release Yoke

29