Installation
5. Note the orientation of the five spring washer stacks on each stud. An O-ring is installed
to keep the washers from falling off. If the washers do fall off during this process, the first
washer is installed with the I.D. cone facing up. The next four washers alternate I.D. cone
facings as shown below.
4.3.3
Mounting the Friction Basket Assembly to the Hub
1. Lift the friction basket assembly by holding two of the six studs.
2. Slide the friction basket assembly over the hub.
•
•
3. Align the mounting holes and using the customer supplied bolts and lock washers, fasten
the friction basket assembly to the machine frame as shown above.
24
Figure 6 Spring Washer Orientation
Figure 7 Mounting the Friction Basket Assembly
If the teeth do not engage easily, apply thumb pressure on the blue friction plate
while rotating the basket clockwise and counterclockwise 45°.
The rotation should cause the teeth to engage the hub disk by disk until the whole
basket comes in contact with the machine frame.
2020 KEB America, Inc.
©