EarthWay 2600A-Plus Estate Assembly And Operating Instructions

2600A-P
lus
B
roAdcAst
ASSEMBLY and OPERATING INSTRUCTIONS
IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS REGARDING
THE SAFE OPERATION OF THIS SPREADER, PLEASE CONTACT US. THIS MODEL INCLUDES LIFETIME TECHNICAL
SUPPORT SUPPORT HOT LINE: 574-848-7491 or 800-294-0671,
HELPFUL HINTS:
; Make sure the ARROW on the gear box points to the front of the spreader. The impeller must turn clockwise. Reversing
the gearbox will cause the impeller to turn counter clockwise. Clean the impeller plate after each use. Fertilizer stuck on the
impeller blades will cause uneven spreading.
; Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds
will change the spread patterns. Wet fertilizer will also change the spread pattern and flow rate. Clean and dry your
spreader thoroughly after each use. A coating of light spray oil will help prevent corrosion. Wash between the shut off
plate and bottom of the hopper.
; Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
1. Remove and identify all loose parts from carton.
Upper handles
Handle Shaft
Wheels
Frame Braces
3. Install gear box by inserting the pinion shaft into hole in center of
hoppers bottom. The ARROW on the gearbox must point to FRONT of
the hopper. Follow label instructions on hopper.
E
stAtE
s
PrEAdEr
REVIEW THE DIRECTIONS BEFORE ASSEMBLY
Gauge &
Linkage
Assembly
Control Rod
Frame
Gearbox
Impeller
Handles
Axle
:
EmAil tEchsuPPort
2. Position hopper as shown to the right.
Install Frame using (4) #10 x 1¼" Flat
Head Phillips screws. TIGHTEN
THESE NOW
Lower
Arrow
EarthWay EarthWay
EV-N-SPRED EV-N-SPRED
Rev. 3-10
@ .
EArthwAy com
® ®
#10 X 1-1/4"
Flat Head Screw
Pt# 52215 PAGE 1