Toyota 5R 1969 Repair Manual page 170

F ig . 9-22 Direction of D riv e
L e v e r Installation
le v e r set bolt.
4 . Install the plate and the rubber plate
onto the drive housing, and then
install the yoke
housing.
F i g . 9-23 Installing Rubber
Plate
5. Install the brush holder onto the
armature, and install the brushes
into the brush holders.
F ig . 9-24 Installing Brush
H older
V1818
onto the drive
, . ;
m m
2
V1819
V1808
S T A R T I N G S Y S T E M - Starter
6. Install the commutator end f r a m e ,
and tighten the through bolts.
7. Install the brake
lock plate onto the armature shaft
en d.
Th e armature
should be 0.05 ~ 0 .35 mm (0 .002
to 0 . 1 3 " ) ,
limit is 0.8 mm (0 .0 31 1 ) .
8. Pack multipurpose g r e a s e into the
end fram e c o v e r , and install it on­
to the end fram e.
F ig . 9-25 Installing End
9 . Install the magnetic switch onto the
drive housing.
A lw a y s hook the moving stud joint
onto the drive
under side of the spring as illus­
trated .
F i g . 9-26 Installing Magnetic
10. Check the clearan ce between the
starter clutch pinion and the pinion
spring and the
shaft thrust play
and the thrust play
F ra m e C o v e r
spring from
Switch
9-11
V1821
the
G0152