Inspection; G O V E Rn O R & Shaft; Distributor C A P - Toyota 5R 1969 Repair Manual

10-6 I G N I T I O N S Y S T E M
2. R em ove the b r e a k e r
ring ( 1 ) , contact point
s c r e w and the b r e a k e r arm lead
w i r e , then
arm (2 ) with the contact point (3)
from the b r e a k e r plate.
F i g . 10-6 Rem oving B r e a k e r V3675
3 . R em o v e the vacuum adva n cer r e ­
taining s c r e w
w i r e retaining s c r e w (2 ) and the
snap ring (3 ) , and then rem o ve
the vacuum a d va n cer ( 4 ) .
F ig . 10-7 Rem oving Vacuum V3676
A d v a n c e r
4 . R e m o v e the housing cap springs,
and r e m o v e the co n d en ser and the
terminal insulators.
5. R e m o v e the
stationary plate.
6 . R e m o v e the
taining s c r e w ,
distributor cam .
- Distributor
arm snap
retaining
rem o ve the b r e a k e r
( 1 ) , adva n cer lead
b r e a k e r plate
distributor cam r e ­
and re m o v e
F i g . 10-8
7 . R em ove the g o v e r n o r springs and
the g o v e r n o r w eigh ts.
8. R em ove the pin, and then rem ove
the spiral g e a r .
T o rem ove the pin, drill the r iv -
etted pin en d .
T a k e c a r e of the 3 ~ 7 w a sh e rs
installed on the g o v e r n o r and plate
at both
housing.

Inspection

Wash all the parts with the exception
of the vacuum advancer and the con­
d en ser in cleaning solvent.
Inspect the following items, and r e ­
pair o r replace any defective p a rt/ s .
G o v e rn o r & Shaft
1. Check
check
butor housing.
2. Inspect the shaft
should
0 .0 0 3 " .
with
3. Check
g o v e r n o r weights with the support
pins fo r
g o v e r n o r
the
fo r w e a r .
T h e
clea ran ce
Removing
Distributor Cam
sides of the distributor
the shaft fo r w e a r , and
the fitness with the distri­
fo r bend which
not ex ceed 0.07
the fitting portions of the
binding, and check the
spring fitting
g o v e r n o r weight
is 0 .2 mm ( 0 . 0 0 8 " ) .
V3678
mm o r
surfaces
and pin