TVS Apache RTR 180 Hyper Edge Owner's Manual page 23

KNOW YOUR APACHE RTR 180
4. Pass by switch
When the pass by switch is pressed intermittently,
the head lamp flashes and signals the approaching
vehicle. This pass by signal can be used while over
taking other vehicle during day time.
5. Head lamp high / low beam switch
With the head lamp switch in 'ON' condition, press
the beam control switch towards '
the head lamp high beam. Press the switch
towards ' ' to turn-on the head lamp low beam.
Warning
Always use the appropriate turn signal lamps when
you intend to change lanes or take turns. Be sure to
switch 'OFF' the turn signal lamps after negotiating
the turns or lanes.
Use appropriate head lamp beam 'high / low' as per
the traffic and road conditions for your safety and to
avoid inconvenience to other riders.
HANDLE BAR RIGHT SIDE
' to turn-on
1. Electric starter switch
Press the electric starter switch '
engine electrically with the transmission is in
neutral or by depressing the clutch lever when the
transmission is in gear.
For cold starts, avoid using electric starter. Use
kickstarter. A typical example is early morning
start. This would reduce load on the battery and
prevents quick drain.
-17-
5
1 2 3
Note
4
' to start the