TVS Apache RTR 180 Hyper Edge Owner's Manual page 22

KNOW YOUR APACHE RTR 180
To reset the trip meter / high speed indicator /
shortest time indicator, set the meter in respective
mode. Press and hold the set switch 'B' for a few
seconds.
DIGITAL CLOCK SETTING
Digital clock can be set in 'ODO' mode only. Set
the digital clock time in the following manner:
1. Change the meter to 'ODO' mode by pressing
mode switch button.
2. Press and hold the mode switch button (A) for
a few seconds to change clock timing to 12 or
24 hour format.
3. Press and hold the set switch button (B) for a
few seconds to enter the clock setting mode.
4. Press the mode switch button (A) to increase
the hours (while hour digits are blinking).
5. To access the minutes press the set switch
button (B) again for few seconds.
6. Press the mode switch button (A) to increase
the minutes (while minute digits are blinking).
7. Press the set switch button (B) to exit the
setting.
HANDLE BAR LEFT SIDE
3
1. Horn switch
Press the switch '
2. Turn signal lamp switch
Slide the turn signal lamp switch to left '
right side ' ' to operate respective turn signal
lamps (LH / RH). Press the knob to turn 'OFF'.
3. Clutch lever
Use the clutch lever to disengage the drive to the
rear wheel while shifting the gears. Squeezing the
lever towards grip disengages the drive.
-16-
5
4
2
1
' to operate the horn.
' or