Adjusting The Headrest; Activating/Deactivating The Audible Signals - Invacare Leo User Manual

A
B
Take note of position and orientation of mounting
hardware before removing.
1. Remove the seat A. Refer to 5.5 Removing/Installing
the seat, page 29.
2. Pull up to remove the top shroud B and expose the
seat post C and mounting hardware.
3. Remove the mounting screw D, two washers E, locknut
F and cap G that secure the seat post to the frame
tube H.
4. Align the frame tube mounting hole with one of five seat
post mounting holes I to achieve desired seat height.
5. Install one washer onto the mounting screw.
6. Insert the mounting screw through the frame tube and
seat post.
7. Install the remaining washer onto the mounting screw.
8. Install the locknut and cap onto the mounting screw to
secure the seat post to the frame tube.
9. Install the top shroud.
10. Install the seat. Refer to 5.5 Removing/Installing the
seat, page 29.
1506942-S
C
E
F
E
G
H

5.9 Adjusting the headrest

1. To raise headrest, push the release button A and lift
headrest up to desired position.
2. To lower headrest, push the release button and lower
headrest to the desired position.

5.10 Activating/Deactivating the Audible Signals

The scooter system emits an audible signal in the following
situations:
• Low Battery Capacity
• Direction Indicators in Use
• Hazard Lamps in Use
The audible signals can be activated or deactivated by
pressing the buttons on the control panel A in a particular
keystroke combination.
Setup
31