Removing/Installing The Batteries - Invacare Leo User Manual

Invacare® Leo
6. Hold the seat post B with one hand.
7. With the other hand, push the release lever C to the
rear of the scooter.
8. Lift the seat post to separate the front frame assembly
D from the rear frame assembly E.
9. Fold tiller down to lowest locked position. Refer to 5.7
Adjusting the Tiller Angle, page 30.
Assembling the Scooter
1. Unfold tiller. Refer to 5.7 Adjusting the Tiller Angle,
page 30.
2. Hold the seat post B and align the curved brackets on
the front frame assembly D with the posts on the rear
frame assembly E.
3. While holding the seat post, slowly pivot the front frame
assembly down until the release lever C locks.
4. Ensure the release lever is locked and the front and
rear frame assemblies are connected.
5. Connect the main wiring harness connector A.
6. Install the batteries. Refer to 8.3 Removing/Installing
the Batteries, page 44.
7. Install the seat. Refer to 5.5 Removing/Installing the
seat, page 29.
8. Install the basket.
44

8.3 Removing/Installing the Batteries

Removing the Batteries
1. Turn power off and remove the key from the ignition.
2. Remove the seat. Refer to 5.5 Removing/Installing the
seat, page 29.
3. Pull up to remove the rear cover.
4. Open the battery retention strap A.
5. Disconnect the battery harness connectors B.
6. Remove the batteries from the base frame.
Installing the Batteries
1. Install the two batteries onto the base frame.
Orient the batteries as shown in the illustration.
2. Connect the battery harness connectors B.
3. Secure the batteries to the base frame using the battery
retention strap A. Securely tighten.
The battery retention strap should go under the
battery harnesses.
4. Install the rear cover.
5. Reinstall the seat. Refer to 5.5 Removing/Installing the
seat, page 29.
1506942-S