Example: RCal Calibration Using a UXA Signal Analyzer
With the RCal module connected to the signal path, press OK to start the calibration:
When the calibration completes, you should (briefly) see the message below:
The table column "Last Calibrated" should show a time stamp for the successful
calibration.
6.
To apply the correction, check the "Apply" column in the row. The table should appear as:
The "Applied" column should show "Yes", indicating that the selected calibration is being
applied. For more detailed information, press the RCal Status button to bring up the status
page:
20
U9361F/M Receiver Calibrator Quick Start Guide