Handheld Controller - PiezoDrive PDUS210 Manual

Handheld Controller

The handheld controller allows the PDUS210 to operate in a stand-alone mode. It is
recommended that suitable settings are found using the assistant and then saved to the amplifier.
The handheld controller can then be used to enable the amplifier and change the output
amplitude.
The amplitude knob on the controller adjusts either the output voltage, current, or power set point,
depending on the selected operating mode.
When the ON button is pressed momentarily, the PDUS210 is armed, which means the output is
enabled but the output amplitude is set to zero. If the ON button is pressed and held, and tracking
functions are enabled and the output is set to the value indicated by the amplitude knob.
The shutdown button will disable the PDUS210 output. The shutdown button only works if the
PDUS210 is enabled by the handheld controller.
To operate the hand controller, the control functions are:
1
4
2
5
3
PDUS210 V4
Description
1,2  Slow alternating flash: armed, output is enabled
but voltage is set to zero.
 Fast alternating flash: output is enabled but
tracking has not locked.
 Solid green: output is enabled and tracking has
locked.
 Solid red: output is disabled.
 Adjusts the output amplitude from zero to the
3
maximum.
 Adjusts the voltage, current, or power depending
on the selected operating mode.
 A short press enables the remote and arms the
4
amplifier.
 Holding the switch on enables the output and any
selected tracking functions.
 Disables amplifier and remote.
5
 Only works if the amplifier is enabled with the
remote.
31 Modified 6/02/2021