Steps
1. Using the alignment posts, place the power-button with optional fingerprint reader into its slot on the palm-rest and
keyboard assembly.
2. Replace the screw (M2x4) that secures the power-button with optional fingerprint reader to the palm-rest and keyboard
assembly.
Next steps
1. Install the
power-button
2. Install the
heat
sink.
3. Install the
GPU
fan.
4. Install the
base
cover.
5. Exit
Service
Mode.
6. Follow the procedure in
Power button with fingerprint reader
Removing the power button with fingerprint reader
Prerequisites
1. Follow the procedure in
2. Enter
Service
Mode.
3. Remove the
base
cover.
4. Remove the
heat
sink.
5. Remove the
GPU
fan.
6. Remove the
power-button
board.
After working inside your
Before working inside your
board.
computer.
computer.
Removing and installing components
53