Steps
1. Place the power button in the slot on the palm-rest and keyboard assembly.
2. Align the screw hole on the power button to the screw hole on the palm-rest and keyboard assembly.
3. Replace the screw (M2x2) to secure the power button to the palm-rest and keyboard assembly.
Next steps
1. Install the
I/O
daughter-board.
2. Install the
base
cover.
3. Follow the procedure in
Power button with optional fingerprint reader
Removing the power button with optional fingerprint reader
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
I/O
daughter-board.
About this task
NOTE:
This procedure applies only to computers shipped with a power button with optional fingerprint reader installed.
The following image indicates the location of the power button with optional fingerprint reader and provides a visual
representation of the removal procedure.
74
Removing and installing Field Replaceable Units (FRUs)
After working inside your
Before working inside your
computer.
computer.