5.2.10 Turbidity control (NTU-Check) (Method 958)
Use
/
enter an individual NTU limit using the keypad. If this function is turned on, parallel
to each measurement the nephelometric turbidity of the sample is determined and
stored. If the turbidity is exceeding your selection, an exclamation mark is displayed next to
the measurement value. Press
5.2.11 Filter 8
(QWHU WKH ZDYHOHQJWK RI WKH VSHFLDO ÀOWHU XVLQJ WKH NH\SDG DQG SUHVV
7KLV FRQÀJXUDWLRQ FDQ RQO\ EH SHUIRUPHG LQ WKH VHUYLFH PRGH 7R FDOLEUDWH WKH VSH-
FLDO ÀOWHU SUHVV
5.2.12 AUTO-OFF (Method 953)
Use
/
WKH LQVWUXPHQW LV QHYHU WXUQHG RII DXWRPDWLFDOO\ PLQ IDFWRU\ VHWWLQJ PLQ
15 min, 20 min, 60 min. Press
5.2.13 SYSTEM-RESET
7KLV FRQÀJXUDWLRQ FDQ RQO\ EH PDGH LQ WKH VHUYLFH PRGH $IWHU DQ DGGLWLRQDO VHFX-
ULW\ FRQÀUPDWLRQ WKH SKRWRPHWHU SHUIRUPV D 6<67(05(6(7 WKXV UHVWRULQJ WKH
state of delivery.
5.2.14 PROG. UPDATE (Method 955)
,Q RUGHU WR SHUIRUP D SURJUDP XSGDWH \RX PXVW ÀUVW LQVWDOO WKH XSGDWH VRIWZDUH
DQG WKH QHZ SURJUDP ÀOH www.mn-net.com) on your computer. Before you start
the update procedure the photometer has to be connected to your computer via
the USB-interface. The photometer should be recognized automatically. If not, activate the
XSGDWHPRGH PDQXDOO\ 7KHUHIRUH FRQÀUP WKH SURJUDP XSGDWH ZLWK
update the photometer restarts.
38
to turn the turbidity control on or off and press
to display the NTU value.
DQG FRQÀUP ZLWK
to adjust the AUTO-OFF time. Five different settings are possible: Off
09.12.2014
. Press
to reset the settings.
WR FRQÀUP
WR FRQÀUP <RX FDQ
WR FRQÀUP
. After a successful