Download Print this page

Electrical Requirements; Installation On Emerson Fans Having A Modular Switch Cup With Center Screw - Emerson LK70LED Owner's Manual

Ceiling fan led light fixture

Advertisement

BP7502 LK70, 80, 90, 140 LED
If your light fixture is to replace an existing ceiling light
fixture, turn electricity off at the main fuse box at this
time and remove the existing light fixture.
!
Do not install or use the light fixture if any part is
missing or damaged. Contact your dealer for
replacement.
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and
the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
3. Installation on Emerson Fans Having a
Modular Switch Cup with Center Screw
3.1
Disconnect electrical power to the branch circuit at the
circuit breaker or fuse box before attempting to install
the light fixture.
3.2
Remove the switch cup from the cover plate by
removing the three screws (retain for future use)
around the side of the switch cup (Figure 1).
Disconnect the motor connector from the switch cup
connector (Figure 1).
Remove the center screw from the switch cup
(Figure 1).
10/13/15
3:02 AM

2. Electrical Requirements

WARNING
WARNING
Page 4
WARNING
!
To avoid fire or shock, follow all wiring instructions
carefully.
Any electrical work not described in these
instructions should be done or approved by a licensed
electrician.
Please
call
Emerson
1-800-654-3545 if you have any questions about
installation and operation of this light fixture.
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and
the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
MOTOR
CONNECTOR
SCREWS (3)
SWITCH
CUP
CENTER SCREW
Figure 1
ETL Model No.: LK70LED/LK71LED/LK72LED/LK74LED/LK77LED/
4
LK80LED/LK81LED/LK83LED/LK90LED/LK91LED/LK140LED/LK141LED
technical
support
at
COVER
PLATE
SWITCH CUP
CONNECTOR

Advertisement

loading