Table of Contents
Advertisement
Connecting machine to power source
1
Always make sure that the machine is
unplugged from power source and the main
switch is on ("O"). when the machine is not in
use and before inserting or removing parts.
Before connecting the power supply, make
sure that the voltage and frequency shown on
the rating plate is conforming with your mains
power.
Place the machine on a stable table.
1. Connect the machine to a power source
2
2. Turn on the power switch.
ON
The sewing lamp will light up when the switch
is turned on.
OFF
v Polarized plug information
This appliance has a polarized plug (one
blade wider than the other), to reduce the
risk of electrical shock; this plug will fit in a
polarized outlet only one way. If the plug does
not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician
to install the proper outlet. Do not modify the
plug in any way.
v Foot Control
With the sewing machine turned off, insert
the foot control plug into its connector on the
sewing machine.
Turn on the sewing machine, and then slowly
depress the foot control to start sewing.
Release the foot control to stop the sewing
machine.
When machine powers on and is in still,
users can quickly kick one step on the foot
controller to change the needle position (up or
down). This action will also automatically set
the needle position when you finish sewing
projects.
Consult a qualified electrician if in doubt as to
connect the machine to the power source.
3
Attention:
as illustrated.
Note:
Advertisement
Table of Contents
