Inserting The Bobbin - Alfa Network Next 100 Instruction Manual

Inserting the bobbin

Attention:
Turn the power switch to off ("O") before
inserting or removing the bobbin.
When inserting or removing the bobbin, the
needle must be fully raised.
Open the needle plate cover.
Insert the bobbin in the bobbin case with the
thread running in a counterclockwise direction
(arrow).
Pull the thread through the slit (A).
Held gently on top of the bobbin with a finger.
Draw the thread at the arrow markings into
the stitch plate thread guide from (A) to (B).
Pull the thread at the arrow markings into the
stitch plate thread guide from (B) to (C).
To cut off excess thread pull thread back over
the cutting off blade at point (C).
Close the needle plate cover.
7