Table of Contents
Advertisement
Free motion darning, embroidery and
monogramming
00
05
3.5
1
1
v Preparation for embroidering
and monogramming
* Embroider hoop is not included with the
machine.
Move the drop feed lever to lower the feed
dogs.
1
Lowered position
Remove the presser foot and the presser foot
holder.
Draw the desired lettering or design on the
surface of the fabric.
Stretch the fabric between the embroidery
hoop as firmly as possible.
Place the fabric under the needle. Make sure
the presser foot bar is down to its lowest
position.
Turn the handwheel towards you to bring up
the lower thread through the fabric. Sew a few
securing stitches at the starting point.
Hold the hoop with thumb and forefinger of
both hands while pressing the material with
the middle and third finger and supporting the
outside of the hoop with your small finger.
Note:
Keep fingers away from moving parts,
especially needles.
When you finish the work, move the drop feed
lever to raise the feed dogs.
1
Raised position
45
Advertisement
Table of Contents
