Download Print this page
IBO QB-60 Instruction Manual

IBO QB-60 Instruction Manual

Surface pumps and water booster sets

Advertisement

Quick Links

NOTE read the manual prior to commencement of use. For safety
reasons, the device can only be operated by persons well-familiarised
with the manual.
NOTE: the manual is the primary part of the purchase and sale contract. The
user's failure to observe the instructions included in the manual is a breach of
the contract and excludes any complaints arising from potential device failure
caused by the use that is inconsistent with instructions of its use.
NOTE: prior to start of the device, please make sure that the capacity
of the well from which you are going to pump the water is sufficient,
i.e. whether the efficiency of the purchased pump is not too high in
relation to the well capacity. Installation of the pump that is too large
can stop the water flow in the suction pipe and result in "dry" pump
operation - without water. Pumps with capacities of 100 l/min and
higher require new, efficient wells !
This equipment is not intended for use by persons (including
children) with reduced motor, sensory or mental capacities, or
persons without experience or not familiarised with the equipment,
unless it is performed under supervision or according to the
instruction regarding operation provided by persons responsible for
their safety.
Attention should be paid so that children do not play with the
equipment.
Surface pumps
and
water booster sets
instruction manual
1

Advertisement

loading

Summary of Contents for IBO QB-60

  • Page 1 Surface pumps water booster sets instruction manual NOTE read the manual prior to commencement of use. For safety reasons, the device can only be operated by persons well-familiarised with the manual. NOTE: the manual is the primary part of the purchase and sale contract. The user’s failure to observe the instructions included in the manual is a breach of the contract and excludes any complaints arising from potential device failure caused by the use that is inconsistent with instructions of its use.
  • Page 2 APPLICATION: Surface pumps and booster pumps which are the subject of this manual are intended for water supply to households from individual water intakes. The devices can also be used to increase pressure, provided that the inflow pressure on the suction side does not exceed 3 bars (300000 Pa).
  • Page 3: Device Installation

    The device is not adjusted to pump caustic, flammable, destructive or explosive substances (e.g. petrol, nitro, oil, etc.), foodstuffs or salty water. Failures caused by pumping of liquids other than pure water are not subject to warranty repairs. The maximal temperature of the pumped water is 35 The device is not adjusted to pump water containing excessive amounts of mineral elements causing deposition of scale on the pumping elements.
  • Page 4: Electric Installation

    The suction pipe must be tight on its entire length. Any potential leakage, e.g. on the connections, result in air suction by the pump. In the best scenario, the pump will not reach the declared parameters. Finally, the pump will operate without water flow, causing its failure.
  • Page 5 When the taps are open, the pressure in the installation drops until it reaches the switch-off value, causing the pressure switch to start the motor. If the switch-on and switch-off pressure do not meet the needs of the user, it is possible to change this range by means of adjustment of the pressure switch.
  • Page 6: Device Disposal

    - to pump failure. Damage resulting from installation leakage are not subject to warranty repairs. QB-60, WZ, WZ, WZC, WZCH, WZI type pumps require unclogging after a standstill period without water. Clogging results from sticking of the rotor to the housing due to the water sediments resulting from evaporation.
  • Page 7 EC DECLARATION OF CONFORMITY (Module A): PHU Dambat, Gawartowa Wola 38, 05-085 KAMPINOS, POLSKA, e-mail: biuro@dambat.pl Under the Act of 30 August 2002 on the conformity system (Journal of Laws of 2004, No. 204, item 2087), we declare, assuming full liability, that the pumps and booster sets with 2L, 24L, 50L capacity tanks, series: JET100A(a)TF, AJ 50/60, MH 1300 (INOX), MHI 1300 (SS), MHI 2200 (SS), MHI 2500 (SS), JSW 150, WZ250, WZ750, QB60, WZ250 hydr 2L, DP355A, JET100A, SCM32, JSW 200,...

This manual is also suitable for:

WzWzcWzchWzi