Constant Rpm Management Control - Kubota M6S-111 Operator's Manual

OPERATING THE TRACTOR
3. Press the switch (A) side and then release the
switch.
4. Press again and hold down the switch (A) side (2.5
seconds) until the buzzer sounds and then release
the switch.
(A) Flashes
5. Press the switch to the (A) or (B) side and set the
speed.
Pressing and holding down the switch will cause
the speed to change continuously. Pressing and
releasing the switch changes the speed by 10 rpm
each time. Set the desired engine speed while
watching the speed display.
94
ELECTRONIC ENGINE CONTROL
(A) Increase speed
(B) Decrease speed
6. If the switch is released and not operated for 4
seconds, a continuous buzzer sounds and the
setting is completed.
7. Follow the same procedure as for the (A) side to set
the speed for the switch (B) side.
NOTE :
• The set speeds will be stored even after the
engine is stopped.
Canceling the setting
Any of the actions below will cancel the RPM dual
memory settings.
1. For the switch (A) side, when the memory speed is
engaged, press the switch (A) again to cancel.
For the switch (B) side, when the memory speed is
engaged, press the switch (B) again to cancel.
2. When the memory speed is canceled, the speed
will return to the speed that is determined by the
hand throttle lever (foot throttle).
When the switch is pressed, the LCD will display
the engine speed that is in effect after memory
speed is canceled.
3. Return the hand throttle lever to the lowest speed
position.
4. Turn the key switch to "OFF".
2. Constant RPM Management
control
Constant RPM Management can be turned "ON" or
"OFF" by operating the switch.
Pressing the switch turns the control "ON" and pressing
the switch again turns it "OFF".
M6S-111,M6L-111,M6H-101