Drawbar; Adjusting Drawbar Length; Swing Drawbar - Kubota M6S-111 Operator's Manual

DRAWBAR

2. Back up the tractor slightly to make sure the lower
links are pushed in securely.
(1) Lever
DRAWBAR
WARNING
To avoid personal injury or death:
• Never pull from the top link, the rear axle or any
point above the drawbar. Doing so could cause
the tractor to tip over rearward.

1. Adjusting drawbar length

1. When towing an implement, it is recommended that
hole (A) in drawbar be utilized.
2. For information about the drawbar load, read the
implement limitations section of this manual.
(See IMPLEMENT LIMITATIONS on page 39.)
(1) Drawbar
M6S-111,M6L-111,M6H-101
(A) "PUSH"
(B) "PULL OUT"
3-POINT HITCH AND DRAWBAR
(1) Pivot pin

2. Swing drawbar

The drawbar can be used in 3 different ways as shown
in the following illustration. Assemble it correctly with
locating pins.
(1) Drawbar
(2) Locating pin
(3) Locking bolt
(A) Hole
(B) Hole
109