Table of Contents
Advertisement
8-10
Aiming Duration (0xED)
It is possible to set certain aiming duration before a scan attempt begins by activating Trigger
Signal or a START_DEC command.
It is programmable in 0.1 second increments from 0.0 to 9.9 seconds. Default setting of aiming
duration is set to 0.0 second.
To set an aiming duration, scan the bar code below and then scan 2 numeric bar codes on page
108 that correspond to the desired aiming duration. If the desired value is a single digit number, it
must have a leading zero. Scan the "0" bar code first.
For example, to set an aiming duration of 0.5 seconds, scan the bar code below, then scan the
"0" and "5" bar codes. To change or cancel an incorrect entry, scan "Cancel" bar code on
page 108.
Aiming Duration
(Default: 0.0 sec)
66
OPTICON
Software Guide
MDL-1000/2000
Advertisement
Table of Contents
